Table of Contents
Advertisement
CF-1LZ and CF-1TX Mechanical Installation
Mounting the clip-fit brackets to the wall:
a. Mount the wall bracket to the desired
surface, in this vertical orientation only.
Note that the bracket has two mounting
holes with vertical spacing that allows
them to be used with a standard wall
J-box.
The hardware for securing the wall bracket
to a mounting surface or a J-box is not
supplied. It is recommended that you
consult a rigging professional to determine
the proper hardware for mounting the
bracket.
Rotating the loudspeaker's input section
(if required):
The SMS1990 loudspeaker can be mounted vertically (as
shown here) onto the clip-fit bracket, or horizontally. If you
want to change the orientation, follow these steps:
a. Remove the four screws holding the circular input
section in place.
b. Pull out the input section by approximately half an
inch, and rotate it through no more than 90 degrees.
c. Secure the input section into its new position with the four screws.
9
CF-1LZ/CF-1TX–
Advertisement
Table of Contents
