Access Codes; User Code Attributes - DSC PowerSeries PC1616 User Manual

When using the PK5500/RFK5500/RFK5564, use the [<][>] keys to find the specific code and press
[,] to select. Enter the new 4 or 6-digit access code, or press [,] to erase it. When programming is
complete, enter another 2-digit code to program or press
For systems using multiple partitions/areas, access codes can be assigned to specific or multiple parti-
tions/areas. Please contact your alarm company for details.
The access codes have programmable attributes which allow zone bypassing, remote access using
the ESCORT5580TC or one-time use activation.
When using 6-digit access codes, the minimum number of variations of access codes are 20833 for
the PC1616, 13888 for the PC1832 and 10638 for the PC1864.

Access Codes

,
[ ][5][Master Code] (when disarmed)
The [,][5] User's Programming command is used to program additional access codes.
User Codes - User Codes 1-48 are available for the PC1616. User Codes 01-72 are available
for the PC1832. User Codes 1-95 are available for the PC1864.
Master Code (Access Code 40)
grammed.
Supervisor Codes
ming section. However, these codes can only program additional codes which have equal or lesser
attributes. Once programmed, the Supervisor Codes receive the Master Code's attributes. These attri-
butes are changeable. Any User Code can be made a supervisor code by enabeling User Code Attri-
bute 1 (please see below for details).
Duress Codes
- Duress codes are standard User Codes that will transmit the Duress Reporting Code
whenever the code is entered to perform any function on the system. Any User Code can be made a
Duress Code by enabeling User Code Attribute 2 (please see below for details).
NOTE:
Duress codes are not valid when entering [,][5], [,][6] or [,][8] sections.
NOTE:
Access codes cannot be programmed as a duplicate or as a "Code +/- 1".

User Code Attributes

1. The default attributes of a new code will be the attributes of the code used to enter [,][5]
whether it is a new code or an existing code being programmed.
2. System Master (Code 40) has Partition Access for all partitions, as well as Attributes 3-4 ON by
default.
NOTE:
These attributes are not changeable.
Inherent Attributes (all codes except installer and maintenance)
Arm / Disarm
- Any Access Code with Partition Access enabled will be valid for arming and disarming
that partition.
Command Outputs ([
Access Code entry, any Access Code with Partition Access will be valid for performing the [,][7][1-
4][Access Code] functions on that partition.
Programmable Attributes ([
1. Supervisor Code
2. Duress Code
3. Zone Bypassing Enabled
4. ESCORT Access
- The Master Code can only be changed by the Installer, if pro-
- These codes are always valid when entering the [,][5] User Code Program-
, ,
][7][1], [ ][7][2], [
,
][5][Master/Supervisor Code][99][Code])
[#]
to exit.
, ,
][7][3], and [
5. For Future Use
6. For Future Use
7. Bell Squawk upon Arming/Disarming
8. One Time Use Code
9
][7][4])
- If these outputs require