Status Lamp - NEC Express5800 series User Manual

STATUS Lamp

The STATUS lamp stays lit in green when the Storage and I/O Blade is in successful operation.
When the STATUS lamp is flashing in amber or red, it indicates that the system has failed.
In addition, you can view the detailed information on error message on virtual LCD when the
STATUS lamp is flashing in amber or red. You can use the virtual LCD through the Web console of
Blade Enclosure. See Chapter 8 for indication on virtual LCD, descriptions, and actions to take. If
an error occurs, contact your service representative.
The following tables list indications of the STATUS lamp, descriptions, and actions to take.
NOTE:
Engine (BMC). You cannot view the error log through NEC ESMPRO
Manager.
STATUS lamp
Status Color
On Green
Off –
On Red
Flash Red
Flash Amber
NOTE:
lamp is flashing in amber or red, the indication of the STATUS lamp is
retained except for certain factors. When the Storage and I/O Blade is
powered on, the STATUS lamp goes on green (normal status).
The Storage and I/O Blade does not support EXPRESSSCOPE
STATUS lamp indications
Description
The Storage and I/O Blade
is operating normally.
The power is turned off.
BMC is being initialized.
See the table "Virtual LCD indications when STATUS lamp is flashing in
red" described in Chapter 8.
See the table "Virtual LCD indications when STATUS lamp is flashing in
amber" described in Chapter 8.
If the Storage and I/O Blade is powered off while the STATUS
General Description 2-9
Action
–
Turn on the power.
1. Wait until the lamp goes off.
2. If the lamp still goes on, check
installation of the Storage and I/O
Blade.