Relocating/Storing The Unit - NEC Express5800 series User Manual

RELOCATING/STORING THE UNIT

Follow the procedure below to relocate or store the Storage and I/O Blade, hard disk drives, and
Blade Enclosure:
IMPORTANT:
If the Storage and I/O Blade needs to be relocated/stored due to a
change in the floor layout to a great extent, contact your service
representative.
Be sure to make a backup copy of your valuable data in the hard
disk drive, if any.
Be sure not to apply a shock to hard disk drives to relocated the
Storage and I/O Blade if the contains any.
It is recommended that the Storage and I/O Blade and the internal
devices should be stored in a place where the room temperature can
be maintained. It is important for the Storage and I/O Blade or
internal devices to work normally after storage. Store the device in
the place where temperature ranges between -10 to 55°C and
humidity ranges between 20 to 80%, without dew condensation.
Observe the following instructions to use the Storage and I/O Blade safely.
Failure to follow these instructions may result in death or serious personal
injury. See pages 1-3 to 1-6 for details.
Do not disassemble, repair, or alter the device.
■
Do not remove the lithium battery.
■
Disconnect the power plug before working with the device.
■
Observe the following instructions to use the Storage and I/O Blade safely.
Failure to follow these instructions may cause a fire, personal injury, or
property damage. See pages 1-3 to 1-6 for details.
Never attempt to lift the unit with three or less persons.
■
Do not install the unit in any place other than specified.
■
Do not connect/disconnect any interface cable with the power cord of the
■
unit plugged to a power source.
WARNING
CAUTION
Maintenance 7-3