Relocating/Storing The Nec Express5800/Ft Series - NEC Express5800/320Lb User Manual

RELOCATING/STORING THE NEC Express5800/ft series

Follow the procedure below to relocate or store the server. (Users should not attempt to remove
the rack-mountable server from the rack assembly.)
Do not attempt to remove the server.
To avoid the risk of personal injury, users should not attempt to remove the
server from the rack assembly. Removal of the server from the rack assembly
should be performed by suitably trained maintenance personnel.
Observe the following instructions to use the server safely. Failure to follow
these instructions may cause a fire, personal injury, or property damage. See
safety precautions in Chapter 1 for details.
• Never attempt to lift the server only by yourself.
• Do not install the server in any place other than specified.
• Do not connect/disconnect any interface cable with the power cord of the
IMPORTANT:
If the server needs to be relocated/stored due to a change in the floor
layout to a great extent, contact the sales agent.
Make sure to make a backup copy of your valuable data in the hard
disk, if any.
When moving the server with hard disks, make sure not to give a
shock to the hard disks .
1.
Take a floppy disk and a CD-ROM out of the server, if any.
2.
Power off the server (the POWER LED goes off).
3.
Unplug the power cord of the server from a power outlet.
4.
Remove all the cables from the server.
5.
Remove the server from the rack cabinet.
6.
Hold the server by its bottom with at least four persons to carry the server.
IMPORTANT:
front bezel may get detached and fall off from the server, causing
damage to the server.
7.
Protect the server with the shock-absorbing materials, and pack it securely.
server plugged to a power source.
Do not hold the front bezel to lift the server. The
WARNING
CAUTION
Maintenance 6-13