Usb Wake-Up - Supermicro Supero C2SBX User Manual

USB Wake-Up

Use JPUSB jumpers to enable the function of "Sys-
tem Waking-Up via USB devices". These jumpers
allow you to "wake up" the system by pressing a
key on the USB keyboard or by clicking the USB
mouse of your system. The JPUSB jumpers are
used together with the USB Wake-Up function in
the BIOS. See the table on the right for jumper set-
tings and jumper connections. Note: JPUSB1 is for
Back Panel USB ports: 0/1/2/3/4/5, and JPUSB2
is for Front Panel USB ports: 6/7/8/9/10/11.
Note: The default jumper setting for JPUSB1/
JPUSB2 is set to "Disabled" by closing both Pin
2 and Pin 3. However, when the USB Wake-Up
feature is enabled in the BIOS, and the selected
USB ports are also enabled via the JPUSB jump-
ers, please be sure to remove all other USB
devices from the USB ports whose USB jumpers
are set to Disabled before the system goes into
the standby mode.
CPU
Processor
A
LAN CTRL
Slot7 PCI-E x1
Slot6 PCI-E x16 GEN2
Slot5 PCI-33 MHz
2
JWOR
JI C1
SMB-to PCI Slots
2
JI C2
Audio CTRL
Slot4 PCI-E x16 GEN2
CD-IN
Slot3 PCI- 33 MHz
JPL1
LAN Enable
Front Audio
Slot2 PCIX-133MHz
Slot1 PCIX-133 MHz
Buzzer
WOL
SPEAKER
CPU Fan
TPM Enable FAN2
JP3
8-Pin PWR
4-Pin PWR
Intel X38
North Bridge
I-SATA5
BIOS
Clear CMOS I-SATA4
I-SATA3
Intel ICH9R
I-SATA2
Battery
South Bridge I-SATA1
I-SATA0
JP2
ITE IDE Enable
JPF
LE1
JWD
ITE 8213
1394
Fire-Wire
IDE CTRL
CTRL
PXH-V
JPI2
1394 Enable
B
FP USB 6/7
USB 11
USB 10
FAN4 FAN3
FP USB 8/9
Fire-Wire1 Fire-Wire2
2-27
Chapter 2: Installation
USB Wake-Up Enable
Jumper Settings
Pin# Definition
1-2 Enabled
2-3 Disabled (default)
A. JPUSB1
B. JPUSB2