Schwinn A.C. Classic Service Manual page 11

Console (cont.)
For any error generated in console.
Problem:
Solution:
1. Refer to Owners manual for description and solution(s).
2. If possible, save the Settings in a USB stick by going to Service Mode -> U-- -> U03.
Exporting Console settings to send to Nautilus for troubleshooting help:
• Go to Service mode by Holding AVG/END + STAGE button for 5 seconds. If workout has started already, stop the
workout , turn the console back on and then hold AVG/END + STAGE button for 5 seconds.
• Go to U-- Menu
• Press backlight
• Go to U03 Menu (Store Data)
• Insert a USB stick
• Press backlight.
• Wait a few seconds (backlight will turn OFF once it has finished writing to the USB)
• Take out the USB
• Get out of Service Mode.
• A file "Config.csv" has been saved onto the USB stick
• Send file to: USBSchwinnAC@nautilus.com
Console's display is frozen.
Problem:
Solution:
1. Remove the battery to restart console.
2. If problem persists, replace the console.
Batteries are being replaced too often.
Problem:
Solution:
1. Check the backlight settings, make sure it is not set to ON (ON at all times).
2. Change backlight settings to stay ON at different rate.
3. With a DMM check for short on the battery leads on the console.
For all other problems refer to the Owner's manual.
11