Advertisement
307-01-24
ASSEMBLY (Continued)
110.
CAUTION: Tightening one screw
before tightening the other may cause the
sensor to bind or become damaged.
NOTE: The manual lever must be in the
NEUTRAL position.
Using the special tool, align the digital TR
sensor and tighten the screws in an alternating
sequence.
• Tighten 10 Nm (89 lb-in).
111.
CAUTION: The splines of the input
shaft are not the same length on both ends.
The shaft end with the shorter splines goes
into the fluid pump.
Install the input shaft.
Automatic Transaxle/Transmission
112. Using the special tool, make sure that the fluid
113. Remove the special tool.
pump gear seal ring is fully seated.
2005 Mustang, 12/2004
307-01-24
Advertisement
