Advertisement
307-01-16
ASSEMBLY (Continued)
72.
CAUTION: If the strut is installed
incorrectly, transmission damage will occur.
Check to make sure that the overdrive band
apply strut is installed in the correct orientation
to the case and piston rod.
73.
CAUTION: The torque specifications
are critical for this procedure. Failure to use
the correct torque specifications may cause
transmission damage.
Install the special tool.
1 Install the special tool and the bolts using
the 2 pump screw locations at
approximately 6 and 12 o'clock positions.
Tighten to 15 Nm (11 lb-ft).
X
2 Tighten the center screw.
Tighten to 1 Nm (10 lb-in).
X
Dimension D
38.05-38.13 mm
(1.50 in)
38.14-38.28 mm
(1.50-1.51 in)
Automatic Transaxle/Transmission
Service Part Number
(7D014)
F7TZ-TA
F7TZ-MA
74. NOTE: Align the disc holes on special tool
with the slot in gauge bar for correct
measurement.
Measure the distance from the top of the gauge
bar to the drum bearing surface through the
hole in the disc and record as dimension A.
Repeat measurement 180 degrees opposite side
of the special tool and record as dimension B.
75. Add dimension A to B, divide by 2 and record
as dimension C.
76. Subtract the thickness of the gauge bar 17.78
mm (0.70 in) from dimension C, and record as
dimension D.
77. Select the No. 1 thrust bearing from the
following chart using dimension D.
Bearing Thickness
1.55-1.60 mm (0.061-0.063
in)
1.75-1.80 mm (0.069-0.071
in)
307-01-16
Identification (Color/ID)
White
Green
2005 Mustang, 12/2004
Advertisement
