Advertisement
307-01-19
ASSEMBLY (Continued)
86.
CAUTION: The overdrive servo must
be installed prior to band adjustment.
Using the special tool, tighten the overdrive
band adjustment screw. Then back off the
screw exactly 1.5 turns and hold that position.
• Tighten to 14 Nm (10 lb-ft).
87. Tighten the overdrive band locknut.
1 Hold the overdrive band adjustment screw
stationary.
2 Tighten the overdrive band locknut.
Tighten to 54 Nm (40 lb-ft).
X
88.
CAUTION: Do not allow the
intermediate band adjusting screw to back
out. Band strut could fall out of position.
CAUTION: Install, but do not tighten,
a new locknut on the band adjustment screw.
Apply petroleum jelly to the locknut seal.
Install new nut on the band adjustment screw.
Automatic Transaxle/Transmission
89.
90. Tighten the intermediate band locknut.
CAUTION: The intermediate servo
must be installed prior to band adjustment.
Tighten the intermediate band adjustment screw.
Then back off the screw exactly 1.5 turns and
hold that position.
• Tighten to 14 Nm (10 lb-ft).
1 Hold the intermediate band adjustment
screw stationary.
2 Tighten the intermediate band locknut.
Tighten to 54 Nm (40 lb-ft).
X
2005 Mustang, 12/2004
307-01-19
Advertisement
