Changing Receiver Squelch Level Setting - Shure UHF WIRELESS User Manual

ENGLISH
6. When the new name has been completely entered, press the MENU button.
"SAVE?" appears, followed by "+ YES – NO". Press the "+" button to save the new
name and return to the Group/Channel/TV display. Press the "–" button to make
more changes. See Figure 24.
NOTE: If more than 20 seconds of inactivity elapse, the display will return to the
original settings.

Changing Receiver Squelch Level Setting

Higher squelch settings demand a quieter signal before muting the receiver, but
reduce operating range. Lower squelch settings extend the operating range, but in-
crease noise levels before dropout occurs. To change the receiver Squelch setting,
proceed as follows:
1. Press the MENU button. The "+ MENU –" display appears, as shown in Figure 25.
2. Press either the + or – button to reach the "SET SQCH" display, shown in Figure 26.
3. Press the SELECT button to display the current squelch level, as shown in Figure
27 (factory preset value is "0.0").
4. Press either the "+" or "–" button to change the Squelch setting in increments of
0.5 until reaching the desired level. The Squelch setting actually changes the mo-
ment you press the "+" and "–" buttons.
FIGURE 24
FIGURE 25
FIGURE 26
MID
FIGURE 27
16