Displaying The Regional Label; Receiving Announcement Information Of Dab Local Stations; Setting For Automatic Change From Dab To Rds; Setting On/Off For Drc (Dynamic Range Control) - Alpine CDA-7894RB Owner's Manual

DAB Operation
BAND
g DN
f UP
TITLE
SETUP

Displaying the Regional Label

The regional name of the ensemble that you are
listening is displayed.
1
Press TITLE button for at least 3 seconds.
"REGIONAL" is displayed for two seconds, and then the
Regional Label is displayed for 5 seconds, and then
you return to the display that you selected with the
steps described under the section "Changing the
Display Mode" on page 29.
NOTES
• If no Regional Label is received, "NO REGON" is
displayed.
• When you are in the Dynamic Label mode, you cannot
display the Regional Label.
Receiving Announcement Information
of DAB Local Stations
1
Press the SETUP button for at least 3 seconds.
2
Press the g DN or f UP button to select "DAB
REG INT."
3
Press the BAND button to select ON or OFF for DAB
REG.
ON: You can automatically receive the announcement
interrupt of the regional you are currently in.
OFF: Announcement interrupt is valid for all regionals.
4
Press SETUP button to return to the normal mode.
30
-EN
Setting for Automatic Change from
DAB to RDS
When the DAB reception is poor, you can set this
selection ON to automatically change to the RDS
station (a station that can be received) within the same
broadcasting station until good reception is achieved.
You can switch this for voice only (except Service label/
Dynamic label display). The display and operation
remain as for DAB.
1
Press the SETUP button for at least 3 seconds.
2
Press the g DN or f UP button to select "RDS/
DAB SW."
3
Press the BAND button to select either ON or OFF.
4
Press the SETUP button to return to the normal mode.
NOTE
When reception is being changed from DAB to RDS, the DAB
indicator blinks.
Setting ON/OFF for DRC (Dynamic
Range Control)
If you set this ON when receiving the sound of a wide
Dynamic Range, the DRC (Dynamic Range Control)
gain increases when the source sound is small, and
the DRC (Dynamic Range Control) gain decreases
when the source sound is large, making the Dynamic
Range narrower to give you better and more
comfortable sound even in the vehicle that produces a
large noise.
1
Press the SETUP button for at least 3 seconds.
2
Press the g DN or f UP button to select "DAB
DRC."
3
Press the BAND button to select either ON or OFF.
4
Press the SETUP button to return to the normal mode.
NOTE
When a radio programme is set to ON, sound other than what
you previously set may be produced depending on the
broadcast. In this case, turn the programme OFF.