Subwoofer On And Off; Sound(Beep) Guide Function; Turning Mute Mode On/Off; Scroll Setting - Alpine CDA-7894RB Owner's Manual

SETUP Operation
BAND
SOURCE
f UP
g DN
SETUP

Subwoofer On and Off

1
Press and hold the SETUP button for at least 3
seconds.
2
Press the g DN or f UP button to select the
SUB-W mode.
3
Press the BAND button to select Subwoofer ON or
OFF.
4
Press the SETUP button after setting the SUB-W ON.
5
Press the MODE button repeatedly to select the
SUB-W mode.
→ SUB-W
VOLUME ← DEFEAT ← FADER ←
Press the g DN or f UP button after selecting the
SUB-W mode, and the subwoofer output phase is
toggled SUBW NOR (0°) or SUBW REV (180°).
6
Turn the Rotary encoder until the desired sound is
obtained in each mode.
NOTES
• Initial mode is "Subwoofer ON."
• Set to "Subwoofer OFF" unless the subwoofer is used.
Sound ( Beep ) Guide Function
This function will give audible feedback with varying
tones depending upon the button pressed.
1
Press and hold the SETUP button for at least 3
seconds.
2
Press the f UP or g DN button to select "BEEP."
3
Press the BAND button to toggle the mode between
BEEP ON and BEEP OFF.
NOTE
The initial setting at the factory is BEEP ON.
4
Press the SETUP button to set the selected mode.
24
-EN
Rotary encoder/MODE
→ BALANCE

Turning Mute Mode On/Off

If a device having the interrupt feature is connected,
audio will be automatically muted whenever the
interrupt signal is received from the device. This
function can be turned ON or OFF from the head unit
by following procedure below.
1
Press and hold the SETUP button for at least 3
seconds.
2
Press the f UP or g DN button to select the
MUTE mode.
3
Press the BAND button to turn on or off the MUTE
mode.
Each press toggles between the MUTE ON and OFF
modes.
NOTE
The initial setting at the factory is "MUTE ON."
4
Press the SETUP button again to return to normal
operation.

Scroll Setting

This CD player can scroll the disc and track names
recorded on CD-TEXT discs, as well as the text
information of MP3 files, folder names, and ID3 tags.
1
Press and hold the SETUP button for at least 3
seconds.
2
Press the f UP or g DN button to select
"SCR(SCROLL)."
3
Press the BAND button to toggle mode between SCR
AUTO and MANUAL.
• SCR AUTO: the CD text information, the text
information of folder and file names, and the ID3
tags are scrolled automatically.
• SCR MANUAL: the display is scrolled only when a disc
is loaded or when a track is changed, etc.
4
When the setting is completed, press the SETUP
button to return to the normal mode.
NOTES
• Initial mode is "SCR MANUAL."
• The unit scrolls CD text names, folder names, file names or
ID3 tag display. The disc titles input manually (refer to page
11) cannot be scrolled.