Advertisement
TX-NR3007/5007 and PR-SC5507 allow you to
update firmware using a USB storage device.
*
In this procedure, on-screen display may vary depending on
the model.
Note:
1. Never unplug or turn off the
AV receiver/controller during updating process.
2. It will take 30 to 40 minutes to update the
firmware.
3. The AV receiver/controller will retain all your
settings after update is finished.
Step1:
Connect a USB storage device to your PC. If there is
any data in the USB storage, remove it.
Step2:
Download the firmware file from the Onkyo web site.
The file name is as follows:
ONKAVR0001_*******.zip
Extract the zip file that you have downloaded. The
following three files are created:
ONKAVR0001_*******.of1
ONKAVR0001_*******.of2
ONKAVR0001_*******.of3
Step3:
Copy the extracted files to the USB storage device. Be
careful not to copy the zip file.
Step4:
Remove the USB storage device from your PC and
connect it to the USB port on the
AV receiver/controller. When the
AV receiver/controller has two USB ports, you can use
either one.
Step5:
Make sure your AV receiver/controller and TV are
turned on.
If the AV receiver/controller is in standby mode, push
[ON/STANDBY] to light up the front display.
Step6:
Select the USB input source. "Now Initializing" is
displayed on the front display and then the name of the
USB storage device is displayed. It will take 20 to 30
seconds to recognize the USB storage device.
4
En-
Updating the Firmware via USB
Step7:
Push [RECEIVER] followed by [SETUP] on the
remote controller.
Main menu will be displayed on TV screen.
Procedures thereafter can also be performed on the
AV receiver/controller by using its SETUP, arrow, and
ENTER buttons.
Step8:
Go to "7. Hardware Setup" menu.
Step9:
Go to "7-6. Firmware Update" menu.
Step10:
Select "Via USB" and push [ENTER].
Advertisement
