Updating The Firmware Via Usb - Onkyo PR-SC5508 Firmware Update

Updating the Firmware via USB

TX-NR5008/TX-NR3008 and PR-SC5508 allow
you to update firmware using a USB storage device.
* In this procedure, on-screen display may vary depend-
ing on the model.
Notes
• Make sure the AV receiver/controller and TV are
turned on.
• Never unplug or turn off the AV receiver/controller
during updating process.
• Never plug or unplug an HDMI cable during updat-
ing process.
• Never unplug the USB storage device containing
the firmware file and the AC power cord during
updating process.
• Do not access the AV receiver/controller from PC
during updating process.
• It will take about 30 minutes to update the firm-
ware.
• The AV receiver/controller will retain all your set-
tings after update is finished.
■Before you start
• Check HDMI Control(RIHD) setting. The update
may not be successful if this setting is on.
• Turn off the controller device connected via
RS232C and via Ethernet network.
• Turn off Zone 2 and Zone 3.
• Stop playback of content from Internet radio, iPod,
USB or servers, etc.
• If there is any data in the USB storage device,
remove it.
How to turn off RIHD
1
In the Main menu select "Hardware Setup".
2
Select "HDMI".
3
Set "HDMI Control(RIHD)" to "Off".
En
5