Table of Contents
Advertisement
Subsystem Syntax
:MONitor:CHANnel
Parameters
Comments
Chapter 5
The
DISPlay
command subsystem monitors the state of the selected multiplexer
channel within the scanning multimeter. This command is useful only with
mainframes that have a front panel display, such as the HP 75000 Series B
Mainframe (Model HP E1301A).
DISPlay
:MONitor
:CHANnel <channel>
:CHANnel?
[:STATe] <mode>
[:STATe]?
DISPlay:MONitor:CHANnel <
monitored. Use the
DISPlay:MONitor:STATe
monitor mode.
Parameter Name
Parameter Type
numeric
channel
<
>
Use the channel parameter to specify a single multiplexer channel within the
scanning multimeter. The channel list is of the form
number and
= channel number
nn
(105 is channel 05 of card number 1, for example).
Use
in place of channel to display measurements from the most recent
AUTO
channel to receive a
CONFigure
measurement are updated as the scan progresses. You may want to add a small
delay to the scan or use a slow, externally paced scan in order to view each
channel from the mainframe's front panel.
The following example shows the multimeter's monitor mode display on the HP
E1301A front panel.
VOLTMTR_8:
mon
Related Commands:
*RST Condition:
DISP:MON:CHAN AUTO
channel
>
selects a single multiplexer channel to be
command to enable and disable the
Range of Values
Refer to the multiplexer user's manual for
a list of channels available.
or
MEASure
command. The channel number and
Chan:
DISPlay:MONitor:STATe
DISPlay
Default Units
none
, where
= card
(@ccnn)
cc
101
+1.465302E-01
volt
Command Reference
136
Advertisement
Table of Contents
