Connecting Your Printer - NEC SuperScript 150C User Manual

Connecting Your Printer

To the electrical power supply
Your printer has no ON-OFF switch and is powered as
soon as you connect it to the electrical power supply.
Before plugging into the power supply socket, make
sure that it is on a stable surface, that the top cover is
closed and read the following warning carefully.
Make sure the power supplied has the voltage indicated
on the electrical data plate on the base of the printer.
If the electrical data plate indicates a different voltage, call
your local retailer immediately. DO NOT, UNDER ANY
CIRCUMSTANCES, CONNECT THE PRINTER TO THE
ELECTRICAL POWER SUPPLY.
Make sure that the plug on the power cable of the printer
is of the type accepted by the wall socket you intend to
use; if it is not, call your local retailer.
Do NOT attempt to change the plug yourself.
The socket outlet shall be installed near the equipment
and shall be easily accessible.
The manufacturer declines all responsibility for accidents
to persons or damage to the printer arising from the
non-observance of this warning.
Quick Start
1. Plug the connector end of the power cord into the
two-pin socket in the rear of the printer.
2. Plug the other end of the power cord into a wall
socket.
As soon as you plug it into the electrical power supply,
your printer will execute a series of internal checks and
a mechanical reset. It will be in ON LINE condition (On
Line light indicator lit).
After approximately 2 minutes of inactivity, the printer
will go into "standby" mode in which both light
indicators are off and the print head is in its rest position
at the left hand end of its path. To activate it, just send a
file to be printed or start any other printer operation.
3