NEC SuperScript 100C User Manual page 41

The paper must not be crumpled or torn, otherwise it may jam or even not be
inserted. Always use paper in perfect condition and within the specifications
defined (see Chapter 3).
Make sure the paper feeds smoothly, and that it is not held too tightly nor has
too much play.
If you remove the paper from or add paper to the ASF, you MUST repeat the
entire paper loading operation.
Always make sure there is no paper inserted for printing before disconnecting
the printer from the mains power supply or before doing the head clearing
operation (see the section entitled "Clearing the print head nozzles"
Chapter 2).
Printing on both sides of the paper may cause smudging.
No paper
If, on a print command, there is no paper to load in the printer, the Power and
On Line LED flash slowly.
To clear this condition, load paper in the ASF and press Form Feed.
2. Paper does not load.
Check that the size and weight of the paper used are within the limits allowed.
Press Form Feed, then repeat the paper loading operation.
If you removed the paper from the ASF, you must press Form Feed, repeat the
entire paper loading operation and then press Form Feed again.
Make sure the paper is not feeding in crookedly.
Paper jamming - point 4 in this section.
Make sure the correct paper feed parameter is selected in your printer driver,
load paper in the ASF and press the Form Feed key on the operator panel.
3. Single sheets/envelopes not loaded (or loaded incorrectly).
The document/envelope has been positioned incorrectly for insertion.
Make sure the correct paper format parameter is selected in your printer
driver.
The print head adjustment lever is positioned incorrectly for the type of
document you are using (see the section entitled "Envelopes" in Chapter 3).
Preprinted documents must have a clean 5 mm margin before the first print
position.
Document is being fed with a reduced linefeed, causing overprinting of
successive print lines.
Remove all the paper from the ASF, press Form Feed and then reload the paper in
the ASF.
. Paper jams or tears.
The most common causes of paper jamming in the ASF is the addition of paper
when the tray is not empty and/or the incorrect loading of paper.
When adding paper to the ASF, ALWAYS remove any paper already present and
reload it all as a single pack.
After clearing a paper jam, ALWAYS remove any paper still in the ASF, press
Form Feed and then reload the paper.
ASF feed mechanism is not synchronized correctly.
in