Adjust Sensor Wash - Miele G 1272 Operating Instructions Manual

Adjust Sensor wash

You can adjust the Sensor wash
programme so that it will remove
stubborn soiling in a lightly soiled load.
^ Open the door.
^ Switch the dishwasher off with the Off
button V.
^ Press the programme selector button
in, and whilst holding it in switch
the dishwasher on using the On
button U .
Keep the programme selector button
pressed in until the lower right hand
programme indicator comes on.
If this does not happen, start the
procedure from the beginning again.
^ Press the Turbo/Combi tabs button
five times.
The Combi tabs indicator light will flash
briefly five times at intervals.
Additional functions
The message flashing in the Time
display shows whether the Adjust
Sensor wash function is activated or
deactivated.
– "p 1": The Adjust Sensor wash
function is activated.
– "p 0": The Adjust Sensor wash
function is deactivated.
^ To change the setting, press the
programme selector button.
Switch the dishwasher off with the Off
button V.
43