Miele KM 83-2 Operating Instructions Manual page 24

Conversion to alternative types of gas
Conversion to alternative types of gas
Check the first intake of air
The air jet must always sit tight with the
marking (a) on the jet holder. If this is
not the case, loosen the securing
screw, re-position the air jet and then
tighten the securing screw.
Re-assemble the hob in the reverse
order.
24
Important note: When reassem-
bling, it is important to ensure that
b
the profile of the facia panel
should grip the appropriate mould-
c
ing on the lower protective cas-
ing.
When the hob well is put back in posi-
tion the ignition electrode and the
thermo element of the spark ignition
must sit firmly in the holes provided.
Put the burner heads back on and
screw into place with the brass
screws, replace the burners caps.
After conversion
After converting the gas hob unit to
an alternative type of gas, stick the
label supplied with the jet kit on to
the data plate over the type of gas
stated.
Check that there are no leakages.
Check that the burner is correctly as-
sembled.
Turn on the gas supply.
Turn on the electricity supply.
Light each of the burners in turn:
When set at "low" the flame should
not go out, nor when the control
knob is quickly turned from "high" to
"low".
When set at "high" the gas flame
must burn with the centre clearly
visible.