Miele DA 262 i Operating Instructions Manual page 22

Installation
Installation
To align
– Height (A):
turn the M 6 x 19 mm adjuster
screws clockwise or anti-clockwise.
– Depth (B):
slightly loosen the hexagonal screws
and move the cooker hood into its
correct position.
Tighten the hexagonal screws up
again.
19 mm thick side walls:
22
16 mm thick side walls:
Secure the cooker hood on both
sides using the 3 x 16 mm screws.
With a 16 mm thick unit side wall use
the spacer washer (1).
Feed the air extraction or air re-circu-
lation connector through as applic-
able, (see chapter "Air extraction" /
"Air re-circulation").
Replace the dividing wall in the wall
unit.
Pull the deflector plate out to its limit
and remove the grease filters.
4 holes (DA 262 i / DA 272 i) or 6 holes
(DA 292 i) are now visible.
Use a sharp pointed instrument
through these holes to gouge out the
fixing holes.
Then screw the cooker hood se-
curely to underside of wall unit.
Replace the grease filters.
1