Miele DA 249-4 Operating And Installation Instructions
Ventilation system
Hide thumbs
Also See for DA 249-4:
- Operating and installation instructions (40 pages) ,
- Operating and installation instructions (44 pages) ,
- Operating and installation instructions (40 pages)
Related Manuals for Miele DA 249-4
Summary of Contents for Miele DA 249-4
- Page 1 Operating and Installation Instructions Ventilation System DA 249-4 To prevent accidents and machine damage, read these instructions before installation or use. M.-Nr. 06 712 720...
-
Page 3: Table Of Contents
Contents IMPORTANT SAFETY INSTRUCTIONS Guide to the hood Functional description Operation Turning on the fan ..........11 Selecting the power level. -
Page 4: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS Read these Operating Instructions carefully before installing or using the Ventilation System. This appliance is intended for residential use only. Use the appliance only for its intended purpose. The manufacturer cannot be held responsible for damages caused by improper use of the hood. - Page 5 However, under certain conditions it may be possible for installation in these applications. Please contact the nearest Miele dealer or the Technical Service Department with specific requirements. Before servicing or cleaning the unit, switch power off at the service...
- Page 6 IMPORTANT SAFETY INSTRUCTIONS , WARNING - TO REDUCE THE RISK OF A COOKTOP GREASE FIRE: Never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillovers may ignite. Heat oils slowly on low or medium settings. Always turn the hood on when cooking at high heat or when cooking flaming foods.
- Page 7 To reduce the risk of fire only use metal ductwork. When installing the hood, follow the recommended minimum safety distances between a Miele cooktop and the hood: – 22" (55 cm) above electric cooktops, – 26" (65 cm) above gas cooktops, –...
-
Page 8: Guide To The Hood
Guide to the hood... -
Page 9: Overhead Lighting
a Chimney extension b Recirculation vent For recirculation use with optional accessories c Chimney d Canopy e Overhead lighting f Active Charcoal Filter Available to purchase, for use in the recirculation mode. g Grease filter h Decor cover i Light button This button turns the light on and off and also dims the light. -
Page 10: Functional Description
Functional description The hood offers two modes of operation: Air extraction The air is drawn in and cleaned by the decor panel and the grease filter and directed outside. The hood comes equipped with a non-return flap. This flap automatically closes when the hood is turned off so that no exchange of outside air and room air can occur. -
Page 11: Operation
Turning on the fan ^ Press the On/Off button. The fan runs at power level "2". The On/Off indicator lights. Selecting the power level ^ Use the "–/+" controls to select the desired power level. + = increases the fan speed –... - Page 12 Operation If the power level indicators "1" and "4" flash, the automatic switch back is not activated. ^ To activate the automatic switch back press the "+" button. The power level indicators "1" and "4" light continuously. ^ To deactivate the automatic switch back press the "–"...
-
Page 13: Delayed Shut Down
Delayed Shut Down If odors or smoke remain in the kitchen after cooking has been completed, the Delayed Shut Down feature can be selected to allow the hood to continue running for either 5 or 15 minutes. ^ Press the Delayed Shut Down button while the fan is still running. -
Page 14: Turning The Lighting On/Off
Operation Turning the lighting on/off The overhead lighting can be turned on and off independently of the fan. ^ Press the light button briefly to turn on the lighting. The light button indicator illuminates. ^ Press the light button briefly again to turn off the lighting. -
Page 15: Filter Timers
Filter timers Grease filter A timer monitors the hours of fan operation. The indicator for the grease filter will light after 30 hours of operation. The grease filter must then be cleaned. After the grease filter have been cleaned and put in place, the grease filter timer must be reset. -
Page 16: Reprogramming The Timers
Operation Reprogramming the timers The grease filter timer is preset to 30 hours. This time can be lengthened or shortened to 20, 30, 40 or 50 hours. – A time of 20 hours should be programmed in kitchens with frequent pan or deep frying. –... - Page 17 Reprogramming the charcoal filter timer The active charcoal filter can only be used in recirculation mode and can not be used to exhaust fumes. The charcoal filter timer is not not preset. Before using the hood in recirculation mode, the charcoal filter timer must be programmed.
-
Page 18: Cleaning And Care
Cleaning and Care Before cleaning or servicing the hood, disconnect it from the power supply by either removing the fuse, unplugging it from the outlet or manually "tripping" the circuit breaker. Cleaning the casing Warning: Never use abrasive cleaners, scouring pads, steel wool or caustic (oven) cleaners on the hood. -
Page 19: Grease Filter
Grease filter The decor panel and reusable metal grease filter remove solid particles from the vented kitchen air (grease, dust, etc). The grease filter is visible when the decor cover is removed. The grease filter should be cleaned every 3 - 4 weeks or whenever the grease filter indicator lights. - Page 20 Cleaning and Care Cleaning the grease filters ^ By hand: use a scrub brush with a solution of warm water and mild detergent. Do not use the pure detergent, aggessive all purpose cleaners, oven sprays or limescale removers. They could destroy the filters. ^ In a dishwasher: place the filters vertically in the lower basket, making sure that the spray arm is not...
-
Page 21: Active Charcoal Filters
The charcoal filter is designed to absorb cooking odors. Replacement active charcoal filters can be ordered from the Miele Technical Service Department. U 1-800-999-1360 V 1-800-565-6435 ^ The decor cover must be removed to access the active charcoal filter. See "Cleaning and Care". - Page 22 Cleaning and Care Replace the active charcoal filter when the charcoal filter indicator lights. Replace the filter at least every 6 months or when it no longer absorbs odors efficiently. The old charcoal filter can be disposed of in the household waste. ^ After replacing the charcoal filters, press and hold the charcoal filter button for about 3 seconds to reset...
-
Page 23: Changing The Light Bulbs
Changing the light bulbs Before changing the light bulbs, disconnect the hood from the power supply by either removing the fuse, unplugging it, or manually "tripping" the circuit breaker. When in use halogen bulbs become extremely hot, and they can burn your hands. -
Page 24: After Sales Service
Miele’s Service department, Extended Service Contracts offered by other providers for Miele products will not be recognized by Miele. Our goal is to prevent unauthorized (and untrained) service personnel from working on your Miele products, possibly doing further damage to them, you and/or your home. -
Page 25: Installation Instructions
Installation Instructions... -
Page 27: Caring For The Environment
Disposal of packing material The cardboard box and packing materials protect the appliance during shipping. They have been designed to be biodegradable and recyclable. Please recycle. To prevent suffocation of children, ensure that any plastic wrappings, bags, etc. are disposed of safely and kept out of their reach. -
Page 28: Installation Accessories
Installation accessories... -
Page 29: Installation
2 protective shields prevent scratches to the chimney during installation. 2 hose clips for securing the ducting. 1 reducing collar for use with 5" (125 mm) exhaust ducting. Upper retaining plate secures the chimney extension. Middle retaining plate for additional stability of the chimney. Lower retaining plate secures the canopy and motor assembly. -
Page 30: Plywood Backing
Plywood backing The majority of the weight of the installed ventilation system will be supported by the lower retaining plate. It must be firmly attached to the stud framing behind the drywall. If studs are not available in the required locations, a plywood backing (min. -
Page 31: Electrical Data
If there is any question concerning the electrical connection of this appliance to your power supply, please consult a licensed electrician or call Miele’s Technical Service Department. 1-800-999-1360 1-800-565-6435 WARNING: THIS APPLIANCE MUST BE... -
Page 32: Appliance Dimensions
Appliance dimensions... -
Page 33: Appliance Dimensions
....(836 - 1066 mm) If the standard unit height H is not suitable to the kitchen’s ceiling height, longer optional chimney extensions are available from your Miele dealer or Miele. " - 38"... -
Page 34: Installation Instructions
Installation Installation instructions ^ See the enclosed installation instruction sheet. ^ Please read the "Important Safety Instructions" and Installation instructions before installing this hood. Protective film The casing is covered with a protective film to prevent scratching during transport. ^ Peel off the film before installing the casing parts. -
Page 35: Air Extraction
" per foot (1 cm per meter) to prevent condensation dripping into the appliance. – If the exhaust is ducted through an outside wall, a Miele Telescopic Wall Vent can be used. -
Page 36: Condensate Trap
Air extraction If the exhaust is ducted into an inactive flue, the air must be expelled parallel to the flow direction of the flue. Never connect an exhaust hood to an active chimney, dryer vent, vent flue, or room venting ductwork. Seek professional advice before connecting an exhaust hood vent to an existing, inactive chimney or vent... - Page 40 Alteration rights reserved / 1106 M.-Nr. 06 712 720 / 00 en - US...