Wall Unit Dimensions; Removing The Transit Strips; Fitting The Cover Caps; Preparing The Lightshield - Miele DA 262 i Operating Instructions Manual

Wall unit dimensions

A: DA 262 i = 562-568; DA 272 i = 662-668;
DA 292 i = 862-868
B: DA 262 i = 600; DA 272 i = 700; DA 292 i = 900
The dividing wall must be remov-
able to enable the cooker hood to
be adjusted for height and depth.

Removing the transit strips

Pull the deflector plate out to its limit.
Pull off the transit strips on each side.

Fitting the cover caps

For cooker hoods without a front panel
or lightshield:
On each side screw in the allen
screws, which are supplied in the
accessories pack.
Push the straight edge of the cover
caps on the screws.

Preparing the lightshield

The weight of the lightshield must not
exceed 900 g.
A heavier lightshield must be planed or
trimmed to reduce the weight.
Lightshields –
– weighing up to 600 g can be fitted
normally.
– Those weighing over 600 g need to
have the springs in the snap fittings
pre-tensioned:
Installation
19