Removing And Fitting The Blade - Flymo EASIMO EM032 Original Instructions Manual

Switch off, wait until the blade has stopped rotating and
disconnect from the mains electricity supply BEFORE
attempting to remove or refit the blade.
Always handle the blade with care - sharp edges could
cause injury. USE GLOVES.
Removing the Blade
1. To remove the blade bolt, hold the blade firmly with a
gloved hand and with a spanner, loosen the blade bolt
by turning it anti-clockwise (S).
2. Remove the blade bolt, washer and blade.(S)
3. Inspect for damage and clean as necessary.
4. In the event of a blade becoming difficult to remove, insert a
screwdriver (T1) into the hole (T2) to lock the drive, then use
a spanner (13mm A/F) to loosen the blade bolt by turning
the spanner anti-clockwise. Ensure the screwdriver is
removed before atempting to turn on the machine.
Renew your metal blade after 50 hours mowing or 2 years
whichever is the sooner - regardless of condition. If the
blade is cracked or damaged replace it with a new one.
Fitting the Blade
1. Fit the blade to the shaft with the sharp edges of the
blade pointing away from the shaft and you are able to
read the text on the blade 'This side to grass'
2. Re-assemble blade bolt through the washer and the blade.
3. Hold the blade firmly with a gloved hand and tighten the
blade bolt firmly with a spanner . Do not over tighten.
Cleaning
• USE GLOVES
• IMPORTANT:- It is very important that you keep your
lawnmower clean. Grass clippings left in any of the air intakes
or under the deck could become a potential fire hazard.
1. Remove grass from under the deck with brush. (V1)
2. Using a soft brush - remove grass clippings from all air intakes
(V2), the discharge chute (V3) and the grass box (V4).
3. Visimo Only - Using a soft brush, remove grass
clippings from the vision window (V5).
4. Wipe over the surface of your lawnmower with a dry cloth (V6).
• IMPORTANT:- Never use water for cleaning your
lawnmower. Do not clean with chemicals, including petrol,
or solvents - some can destroy critical plastic parts.
Storing your Cable (Visimo & Rollermo only)
• Your electric cable can be wrapped around the cable
wrap wing knobs to enable tidy and safe storage (W1).
Storing your Lawnmower:
• Loosen the wing knobs to enable the handles to be
folded over the product (W2).
• Store in a dry place where your lawnmower is
protected from damage
At the End of the Mowing Season
1. Replace blade, bolts, nuts or screws, if necessary.
2. Clean your lawnmower thoroughly.
3. Make sure that the electric cable is stored correctly to
prevent damage.
W1

Removing and Fitting the Blade

Caring for your Lawnmower
S
blade bolt
washer
blade
T
1
2
V1
V3
V5
Visimo Only
W2
V2
V4
V6