New Balance NBP01075-2 Owner's Manual page 8

STEP 3 – Handlebar Tube Assembly
a) Remove the two Allen Bolts, Washers and Phillips Screw
from the Handlebar Tube.
b) Slip the Handlebar Tube Cover onto the Handlebar Tube as shown.
The Handlebar Tube should lean back towards the back of unit.
c) Remove the wire tie from the wires inside the Main Frame Assembly
where the Handlebar Tube will go. Attach the four wires from the
Main Frame Assembly to the four wires coming out the bottom of
the Handlebar Tube.
d) Insert the Handlebar Tube into the Main Frame Assembly, tucking
the wires down into the Main Frame Assembly. Reinsert the Allen
Bolts and Washers you removed in (a). Be careful not
to pinch the wires. NOTE: Gently pull the wires up from the
top of the Handlebar Tube to prevent any slack in the
wires at the base of the Handlebar Tube. Hand tighten.
e) Secure the Handlebar Tube in place with the
three Allen Bolts, Washers and Nylon Nuts from
the Fastener Pack. Tighten with the Wrench provided.
Also tighten the bolts used
in step (d).
f) Let the Handlebar Tube Cover
slip into place. Push it down
gently until it clicks. Secure in
place with the Phillips Screw
you removed in (a).
STEP 4 – Seat Carriage Assembly
a) Remove the Plastic Stoppers and the two small Phillips
Screws at the back of the Seat Carriage Tube. Slide off the
Carriage End Cap letting it gently hang.
b) Holding the Seat Carriage Assembly by the front of Seat
Cushion and the top of the Back Rest, slide it onto the Seat
Carriage Tube. Lift up on the Seat Carriage Locking Knob
and slide the Seat Carriage Assembly on the Seat Carriage
Tube until the Seat Carriage Locking Knob locks into a slot.
c) Replace the Plastic Stoppers, Carriage
End Cap and Phillips Screws you
removed in (a).
d) Plug the wire from the rear of the
Seat Carriage Tube into the wires
coming from the Handlebar on
the lower back of the Seat
Carriage Assembly.
seat carriage
locking knob
seat carriage
tube
M8 x 60mm allen bolts,
M8 washers and M8 nylon nuts
4b
4d
3a
phillips
screw
remove allen
bolts & washers
3d
re-insert allen
bolts & washers
from step a
allen bolts,
washers & nuts
from fastener
pack
3e
STEP 5 – Foot Pedal Assembly
The Foot Pedals and the Foot Pedal
Cranks are marked "L" and "R".
Using the Wrench provided, attach the
left Foot Pedal to the left Crank rotating
the Wrench counter-clockwise.
Do not try to turn clockwise. You will
strip the threads.
Attach the right Foot Pedal to the right
Crank rotating the Wrench clockwise.
left foot
pedal
4a 4c
plastic stoppers
left side shown
looking from the
phillips
back of the unit
screw
carriage
end cap
wire
opening in
handlebar tube
towards back
3d
3b
3c
left
crank
"L" & "R"
markings are
located on the
ends of the
pedal shaft.
7