Advertisement
AGP-2 / ABGP
holes from the inside of the guitar. Next, measure the length of the threaded
bushing that protrudes out from the side of the instrument. From this mea-
surement, subtract the thickness of the outside hardware (hex nut and finish
washer).
FIG. 2
5. WIRING THE TRANSDUCER
Remove the cover from
the AGP-2 Preamp.
Locate the terminal block
with two sections to be
used to connect the
transducer leads (see
Figure 2). Thread the
transducer wire through
the rubber grommet
where the wire harness
enters the preamp. Strip
and tin the signal and ground wires from the transducer and connect them
to the terminal block as shown in Figure 2. Check for shorts. Replace the
cover and screws (SEE NEXT SECTION), being careful to engage the grom-
met in the appropriate slot.
6. MOUNTING THE BATTERY HOLDER
The AGP-2 is supplied with a battery holder that can be attached to the pre-
amp cover with the screws provided (see Figure 3), or be attached to the
neck block (see Section 6a).
Be sure to check and adjust the fit of the battery in the holder before
installing the AGP-2 Preamp inside the instrument.
6a. OPTIONAL BATTERY HOLDER MOUNT
Cut a block of 1/4" plywood approximately 1-1/2" x 2-1/2" (40mm x 65mm).
Using two Number 4 pan-head sheet metal screws (1/4" length), attach the
battery holder to the wooden block. The assembly can then be attached to
the neck block with wood glue, double sided tape, or Velcro.
4
Advertisement
