Related Manuals for Fishman AGP-2
Summary of Contents for Fishman AGP-2
- Page 1 I n s t a l l a t i o n G u i d e I n s t a l l a t i o n G u i d e AGP-2 Onboard Acoustic Guitar Preamp Also includes Installation Instructions for Model ABGP Onboard...
- Page 2 N N O O T T E E : : If you have purchased the AGP-2 Preamp Kit that includes the Fishman AG-125 Acoustic Guitar Transducer, be sure to see the enclosed separate instructions to guide you in proper installation of the transducer.
-
Page 3: Installation
I n s t a l l a t i o n G u i d e I n s t a l l a t i o n G u i d e NSTALLATION 1. Location Determine the best location for the Preamp on your instrument. We recommend the upper bout adjacent to the neck, or in the waist area. -
Page 4: Wiring The Transducer
(hex nut and finish washer). 5. Wiring the Transducer Remove the cover from the AGP-2 Preamp. Locate the terminal block with two sec- tions to be used to connect the transducer leads (see Figure 2). Thread the trans- ducer wire through the rubber grommet where the wire harness enters the preamp. - Page 5 FAILURE TO REMOVE BATTERY COULD RESULT IN DAMAGE TO YOUR INSTRU- MENT. Fishman will not be held responsible for any such damage as a result of shipping or handling.
- Page 6 AGP-2 AGP-2 Onboard Acoustic Guitar Preamp Onboard Acoustic Guitar Preamp 7. Mount the Preamp Slip the wooden spacer block (prepared earlier) over the control bushings and mount the preamp. The outside hardware should include a smooth 3/8” dress wash- er and a 3/8” hex nut. Tighten the hex nut.
- Page 7 I n s t a l l a t i o n G u i d e I n s t a l l a t i o n G u i d e 9. Wiring the Switchjack 1. Gently bend back the strain relief/sleeve tab to gain better access to the Tip ter- minal.
-
Page 8: Ready To Play
The power is switched on when a 1/4” guitar cable is plugged into the output jack. The AGP-2 features a “soft” turn on mode. This means that the unit powers up grad- ually over several seconds once the instrument is plugged in. - Page 9 I n s t a l l a t i o n G u i d e I n s t a l l a t i o n G u i d e Wiring Options with the Fishman Switchjack The Switchjack T-R-S-S (Tip/Ring/Sleeve/Switch) stereo switching endpin jack allows simultaneous stereo operation and battery switching for active pickups.
- Page 10 AGP-2 AGP-2 Onboard Acoustic Guitar Preamp Onboard Acoustic Guitar Preamp Wiring Options with the Fishman Switchjack , Continued Standard wiring for AGP-2 Standard wiring for AGP-2 Negative Battery Wire (black) to Switch AGP-2 Signal Shield to to Tip (white) Sleeve...
- Page 11 I n s t a l l a t i o n G u i d e I n s t a l l a t i o n G u i d e Wiring Options with the Fishman Switchjack Continued Add a Microphone in Stereo...
-
Page 12: Return Policy
One (1) Year from the date of purchase. If the unit fails to function properly within the warranty period, free repair and the option of replacement or refund in the event that FISHMAN is unable to make repair are FISHMAN’s only obligations. This warranty does not cover any consequential damages or damage to the unit due to misuse, accident, or neglect.