Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Fishman Fission Bass Powerchord FX
Summary of Contents for Fishman Fission Bass Powerchord FX
- Page 1 USER GUIDE FISSION BASS™...
-
Page 2: Quick Start
Fission Bass will both enhance and inspire your music making. Quick Start Power – Install a fresh 9V battery (not included) or connect a Fishman power adaptor. Set the controls – set effect level at minimum and all other controls as shown. -
Page 3: Quick Start Settings
Quick Start Settings clip | batt signal noise gate overdrive tone effect level fission octave up 4th below upper octave 5th above POWERCHORD FX effect on... -
Page 4: Making Connections
Making Connections Input Plug in your bass guitar here with a standard ¼-inch instrument cable. Insert a plug into the input jack, and Fission Bass powers up. To conserve the battery, remove the plug from the input when not in use. Trim Raise or lower the trim to optimize the input level for your pickup. -
Page 5: Right Side
Right Side... - Page 6 9VDC Power may be supplied by either a 9V battery ( battery compartment underneath the pedal ) or the Fishman 910-R AC adapter. When the clip|batt LED comes on you have approximately one hour of remaining battery life...
-
Page 7: Left Side
Left Side... -
Page 8: Foot Switches
Foot Switches Effect On / Octave Up Press to engage effect, adding an octave above the played note. When disengaged, any enabled foot switch lights are dimmed. 4th Below Press to add an interval of one 4th below the octave effect. 5th Above Press to add an interval of one 5th above the octave effect. - Page 9 Foot Switch Intervals Effect On/ 4th Below 5th Above Upper Octave + 5th Octave Up Octave Up Octave Up + Octave Up...
- Page 10 Controls Noise Gate The noise gate can reduce the amount of unwanted noise between the decay of one note and the attack of the next. Turning the control counter-clockwise reduces the decaying noise more quickly. Overdrive Use this to control the amount of overdrive applied to the pitch shift effect. When set fully counter-clockwise, there is no overdrive.
- Page 11 Typical in-use current consumption: 24mA Typical 9V battery life: 20hours (alkaline) / 40hours (lithium) Fishman 910-R ( for 110V ) 9V adapter: or suitable fi ltered and regulated, 200mA type, center pin = negative All specifi cations subject to change without notice.
- Page 12 Fishman, Fishman Transducers and Fission Bass are all trademarks, registered trademarks or trade names of Fishman Transducers, Inc. 513-100-182 Rev B 6-11...