Table of Contents
Advertisement
Chapter 2. CLI Syntax Reference
/cx show carvesize
/cx show ctlbus
/cx show driver
/cx show dpmstat [type=inst|ra|ext]
39
This feature only applies to 9000 series SX/SE/SA model controllers.
This command shows the maximum size of the volumes that will be created if
the autocarve policy is set to on. The carvesize can be set between 1024 GB
and 32768 GB (1 TB to 32 TB). Default carvesize is 2048 GB (2 TB). For
more information see, "/cx show autocarve" above.
Example:
//localhost> /c0 show carvesize
/c0 Auto-Carving Size = 2000 GB
This feature only applies to 9000 series SX/SE/SA model controllers.
This command reports the controller host bus type, bus speed, and bus width.
Example for 9690SA:
//localhost> /c2 show ctlbus
/c2 Controller Bus Type = PCIe
/c2 Controller Bus Width = 8 lanes
/c2 Controller Bus Speed = 2.5 Gbps/lane
This command reports the device driver version associated with controller
/cx.
Example:
//localhost> /c0 show driver
/c0 Driver Version = 3.x
This feature only applies to 9000 series SX/SE/SA model controller. The
type=ext feature is only for SE/SA controllers.
This command shows the configuration and setting of the Drive Performance
Monitor, and a summary of statistics for drives attached to the controller.
The optional type attribute specifies which statistics will be displayed. The
available options are: inst for Instantaneous, ra for Running Average, and ext
for Extended Drive Statistics. If you do not specify a type, the display will
show the default set of drive statistics, which is the type inst.
inst (Instantaneous). This measurement provides a short duration average.
ra (Running Average). Running average is a measure of long-term averages
that smooth out the data, and results in older results fading from the average
over time.
3ware SAS/SATA RAID Controller CLI Guide, Version 9.5.2
Advertisement
Table of Contents
