Cx/Ex Show Attribute [Attribute; Cx/Ex Show Controllers; Cx/Ex/ Show Diag=Helptext - 3Ware 720-0192-00 Manual

Chapter 2. CLI Syntax Reference
x x
/c /e show

/cx/ex show controllers

/cx/ex/ show diag=helptext

125
Slot Status
--------------------------------------------------
slot0 OK
slot1 NO-DEVICE
slot2 OK
slot3 OK
slot4 OK
slot5 OK
slot6 OK
slot7 OK
slot8 OK
slot9 OK
slot10 OK
slot11 NO-DEVICE
Alarm Status
--------------------------------------------------
alm0 OK
attribute attribute
[
This command is used with the 9690SA controller. For the 9650SE, simply
drop the prepended controller name in the command and use /ex.
This command shows the current setting of the given attribute(s). One or
many attributes can be requested. An invalid attribute will terminate the loop.
Possible attributes are: controllers, slots, fans, temp, pwrs (power supply), and
alms (alarms).
This command is used with the 9690SA controller. For the 9650SE, simply
drop the prepended controller name in the command and use /ex. This
command is primarily useful for 9650SE controllers, where the enclosure
number may not already be known.
This command lists the controller associated with enclosure /cx/ex.
Example:
//localhost> /e0 show controllers
e0 connects to controller /c0
This command is used with the 9690SA controller. For the 9650SE, simply
drop the prepended controller name in the command and use /ex.
This command allows you to view the enclosure diagnostic log. What is
reported by this log will vary depending upon the manufacturer of the
enclosure. The enclosure diagnostic log may be requested by 3ware Customer
Support to help troubleshoot problems on your controller.
3ware SAS/SATA RAID Controller CLI Guide, Version 9.5.2
VPort Identify
/c0/p0 Off
- Off
/c0/p1 Off
/c0/p2 Off
/c0/p3 Off
/c0/p4 Off
/c0/p5 Off
/c0/p6 Off
/c0/p7 Off
/c0/p8 Off
/c0/p9 Off
- Off
State Audibility
OFF UNMUTE
...]