Normal Copying; Copying From The Automatic Document Feeder - Sharp AR-3551 Operation Manual

NORMAL COPYING

This section describes the normal copying procedure.

Copying from the automatic document feeder

■ ■ ■ ■ ■ 1-sided copies of 1-sided originals
Original
1
Place the originals in the document feeder tray.
(page 7)
2
Ensure that the 1-sided to 1-sided copy mode
is selected.
ORIGINAL A4
A4
A4
1.
A4
2.
A3
3.
A4R
4.
3
Touch the [2-SIDED COPY] key.
2-SIDED COPY
OUTPUT
4
Touch the [1-sided to 1-sided copy] key.
Copy
The one-sided to one-sided
mode is selected when no
icon for a two-sided mode
appears in the dashed area
on the display. If the 1-sided
to 1-sided copy mode is
already selected, steps 3 to
5 are not needed.
The [1-sided to 1-sided] key
will be highlighted.
5
Touch the [OK] key.
0
OK
6
Ensure that paper of the same size as the
originals is automatically selected. (✼Note)
AUTO
A4
PAPER SELECT
%
100
COPY RATIO
(✼Note) The following requirements must be satisfied.
●
Originals of a standard size (11" x 17", 8-1/2" x 14", 8-1/2"
x 11", 8-1/2" x 11"R, 5-1/2" x 8-1/2", A3, B4, A4, A4R or
A5) are set and the auto paper select function is enabled.
PLAIN
1.
A4
2.
A4 TRANSPA
1
X
3.
A3 PLAIN
The selected tray will be
highlighted or the message
"LOAD xxxxxx PAPER." will
appear. If the message ap-
pears, load paper in a pa-
per tray or the bypass tray
with paper of the required
size. Even if the message
above is displayed, copying
can be performed onto the
currently selected paper.
If originals of a size other
than the sizes above are to
be copied, manually select
the desired paper size.
9