Network Settings - Sharp AR-3551 Operation Manual

■ Network settings

These programs are set when this product is used
as a network printer.
After each program is set, exit the key operator
program, turn off the main switch, and then turn on
the main switch again after a while. The program
that has been set will be effective at this time.
NOTE
For setting and modification of
sure to consult with the network administrator.
IP address setting
When using this product in a network that uses the
TCP/IP protocol, use this program to set the IP
address (IP address, IP subnet mask, and IP
gateway) of this product. The program is set to
ENABLE DHCP by factory default setting, which has
the IP address setting obtained automatically. When
using this product in a network that uses the TCP/IP
protocol, set also the program "Enable TCP/IP" below.
{IP address setting}
Same as for the main unit.
Enable TCP/IP
When using this product in a network that uses the
TCP/IP protocol, set this program. Also set the IP
address using the program "IP address setting"
above.
{Enable TCP/IP}
Same as for the main unit.
Enable NetWare
When using this product in a network that uses the
NetWare protocol, set this program.
{Enable NetWare}
Same as for the main unit.
Enable EtherTalk
When using this product in a network that uses the
EtherTalk protocol, set this program.
{Enable EtherTalk}
Same as for the main unit.
Network settings , be
" "
KEY OPERATOR PROGRAMS
Enable NetBEUI
When using this product in a network that uses the
NetBEUI protocol, set this program.
{Enable NetBEUI}
Same as for the main unit.
Reset the NIC
This program is used to reset all setting items of
NIC (Network Interface Card, namely Print Server
Card) of this product to the factory default settings.
{Reset the NIC}
Same as for the main unit.
6
6-13