Margin Shift - Sharp SF-2540 Operation Manual

MARGIN SHIFT

The MARGIN SHIFT feature, in its initial setting, automatically shifts
the text or image to the right on one-sided copies. If two-sided
copying is made possible by using an optional duplex module, the
image is shifted to the right on the front side of copies and to the left
on the second side. Shift direction can be changed in the manner
described below in steps 3 through 5.
The standard shift amount setting is 9 mm (1/4"), but can be
changed to 0 mm, 3 mm, 6 mm, 12 mm, or 15 mm (0", 1/8", 3/8",
1/2", or 5/8") as desired.
KEY OPERATOR The initial shift setting can be changed to 0 mm,
3 mm, 6 mm, 9 mm, 12 mm, or 15 mm (0", 1/8", 1/4", 3/8", 1/2", or
5/8"). See page 89. Shift direction change can be disabled. See page
91.
Original
Expanded margin
Margin is expanded here.
ERASE MARGIN
SHIFT
AUTO
AL TO COPY
Copy
(Initial setting:
copy image shifted to the right)
Place the original face down on the document glass
1
and close the document cover.
If an optional reversing automatic document feeder is installed,
you can place the originals face up in the document feeder tray.
Press the MARGIN SHIFT key.
2
The following message will appear for several seconds.
DUAL PAG
COPY
If an optional duplex module is installed and a two-sided
copying mode is selected, the margin shift selection for the
second side will also be displayed.
Then the message will change to the following.
READY TO COPY.
SPECIAL MODE SELECTED.
TO CHANGE: PRESS
NOTE:
The front side and second side are
referred to as "SIDE 1" and "SIDE 2"
respectively in the message display.
MARGIN SHIFT TO CHANGE: PRESS
•SIDE 1
RIGHT 9mm
KEY.
17