Power On And Off; Power Save Modes - Sharp SF-2540 Operation Manual

POWER ON AND OFF

Power on
Power off

Power save modes

The copier has two power save modes to reduce overall power
consumption and thereby reduce the cost of operation and to conserve
natural resources to help reduce environmental pollution. The two
power save modes are preheat mode and auto power shut-off mode.
KEY OPERATOR
The preheat activation time and the auto power shut-off time have
been preset at the factory to 15 min. for preheat mode and 60 min. for
auto power shut-off mode. These times can be changed as described in
the key operator's guide section. It is suggested that you set
appropriate times according to the actual usage of the copier.
E S
The ® guidelines
NERGY TAR
are applied to the products only
in Europe, Australia and New
Zealand. The products that meet
E S
®
the guidelines
NERGY TAR
carry the logo shown above. The
products without the logo may
E
not meet the
NERGY
guidelines.
The Environmental Choice
Program guidelines are applied to
the products only in Canada.
4
The power switch is located on the left side of the copier. When the
power switch is turned to the "ON" position, the message "WARMING
UP. PLEASE WAIT." will appear in the message display. Warming
up takes about 100 seconds. Once the copier is ready, the message
display will change to "READY TO COPY.", and the START key
indicator will light up, indicating that copying is possible.
If the copier has been programmed in the auditing mode, the
message "ENTER YOUR ACCOUNT NUMBER. -----" will appear
after warming up. Once a valid account number has been entered,
the message will change to "READY TO COPY." and the START key
indicator will light up.
Auto power shut-off mode
If the auto power shut-off mode is enabled, the copier will automatically
turn off the power once a programmed length of time has elapsed without
any copier operation after the last copy of a run is made or the power is first
turned on. The power switch will automatically be turned to the "OFF"
position.
To turn the power back on, simply turn the power switch to the "ON"
position.
KEY OPERATOR See page 87 for setting the auto power shut-off timer. See
page 96 for enabling or disabling the auto power shut-off mode.
S
®
TAR
Preheat mode
The copier will enter the mode once the set time has elapsed without any
copier operation after the last copy of a run is made or power is turned on.
When the copier enters the preheat mode, the message "PREHEAT
MODE. PRESS ANY KEY ON THE OPERATION PANEL TO RESTORE
THE COPIER TO "READY TO COPY"." will appear.
In this condition, the fuser in the copier is maintained at a lower heat level
thereby saving power. The preheat level is, however, high enough to allow
the copier to come to a ready condition or begin copying approximately 30
seconds after any key input is made.
To copy from the preheat mode, make desired copier selections and press
the START key using the normal copying procedure.
KEY OPERATOR See page 91 for information on setting the preheat mode.