Transom Mount - Lowrance Transducer Installation Manual

Transom mount

The transducer should be installed parallel with the transom's waterline, not the bottom of the boat
(deadrise).
NOTE: Ensure the entire bottom surface of the transducer hangs at least couple of millimeters
(1/16ths of an inch) lower than the bottom of the hull.
Hold the transducer with bracket up to the transom of the boat and trace the
slotted screw hole locations (two on the 83/200 KHz transducer, and four on
the 50/200 KHz transducer). Mark drilling points in the middle of each outline,
to allow for transducer height adjustment. Drill pilot holes to suit fasteners.
10