Aligning Ratchets On Bracket - Lowrance Transducer Installation Manual

Aligning Ratchets on bracket

Ratchets help you adjust the transducer so it is parallel to the ground.
1. I nsert the ratchets into the bracket with the letter "A" aligned with the dot
stamped on the outside of the transducer bracket.
2. S lide the transducer into the bracket and slide the bolt through the
transducer bracket.
3. H old the transducer assembly against the transom. Look at the transducer from the side. If
it is parallel to the ground, then the "A" position is correct.
4. I f the transducer face is not parallel to the ground, repeat Steps 1-3 aligning letter "B"
aligned with the dot stamped in the bracket.
5. C heck to see if the transducer will adjust so its face is parallel with the ground. Repeat this
process until the transducer face is parallel to the ground.
Ratchet
One-piece bracket
Bracket
9
Ratchet
Bracket
Two-piece bracket
Align dot and
letter "A".
dot
A