Transom Mount - Lowrance StructureScan Installation Manual

Transom Mount

The StructureScan transducer can be mounted just like a skimmer transducer, where
it is in the water when you are on plane or can be mounted so it is only in the water,
when you are moving at trolling speed.
1/8" Drill bit (Transom mount pilot holes)
Transom Mount (Aluminum Hull) Supplies (not included)
M4 Machine Screws
Starboard (prevents corrosion between bracket and aluminum hull)
To Mount StructureScan on Transom:
1. Choose a transducer location and then route the transducer cable to
the location where the LSS-1 will be installed.
2. Place the transducer bracket against the transom and then align
the bottom of the transducer
with the bottom of boat. Use
a pencil to mark the pilot
holes through the slots in
the transducer bracket.
3. Drill the pilot holes into the
boat's transom.
4. Apply a high-grade above-
or below-waterline sealant
to the pilot holes.
5. Align the bracket slots over
the pilot holes and fasten
the bracket to the transom
using your drill and the
supplied screws.
6. To make adjustments to transducer position, loosen the screws and
slide bracket up or down.
7. Connect the transducer cable to the LSS-1 sonar port.
CAUTION: If you have an aluminum boat, install a piece of marine
!
starboard between the stainless steel StructureScan transducer bracket
and the transom to prevent corrosion.
Transom Mount Supplies (not included)
Marine grade above- or below-
waterline sealant
Marine grade above- or below-
waterline sealant
StructureScan transducer mounted on
transom.
6