Table of Contents
Advertisement
RUGGEDCOM RX1512
Installation Guide
• Serial Console:
Section 3.4, "Serial Console Port"
• Management Ethernet Interface:
• Critical Alarm (Failsafe) Relay Interface:
Section 2.2.1
Module Status LEDs
The front panel module status LEDs provide the following information:
Table: Module Status LED Indications
LED
PM
LM 1 through 2
Section 2.3
Line Modules (LM)
The RUGGEDCOM RX1512 supports two line modules in slots LM1 through LM2. Several types of line modules
may be ordered, depending on the type, speed and number of Ethernet ports required.
The following illustrations show the typical port configurations and connectors available for RX1512 line modules.
For complete information on the available line modules, refer to the RUGGEDCOM RX1512 data sheet.
NOTE
Only one T1/E1 module may be used per router.
Section 2.3.1
Ethernet - Copper
Figure 3: CG01: 2 × 10/100/1000TX RJ45
Module Status LEDs
Section 3.7, "Copper Ethernet Ports"
Section 3.3, "Critical Alarm Wiring"
Purpose
Indicates power supply status.
Indicates the line module status.
Figure 4: CG03: 2 x 8-Pin 10/100/1000TX M12
RUGGEDCOM Modules
Description
I = Power supply is receiving input voltage.
O = Power supply is providing
output voltage to the RX1512.
Green = OK
Orange = Warning alert
Red = Configuration error
Chapter 2
7
Advertisement
Table of Contents
