Port (Usb-Midi Port Setting) - Korg microKONTROL Owner's Manual

Operation–Setting mode

[8] PORT (USB-MIDI Port setting)

The USB-MIDI Port setting page lets you specify the USB-MIDI transmission
port that each controller will use when the microKONTROL is connected to
a computer via USB. You can specify the transmission port separately for
each controller.
These port settings apply only to the USB connection. All MIDI
messages will be transmitted from the MIDI OUT connector, regardless
of the port settings.
1 Hold down the [SETTING] key and press pad [8].
The [SETTING] key and pad [8] will light, and you will be in the USB-
MIDI Port setting page. The main display will indicate "Controller
Select" (select the controller for which you want to make settings).
2 Use the [VALUE] dial to select the controller whose transmission port
you want to specify.
Encoder
Specify the transmission port for the encoders.
Slider
Specify the transmission port for the sliders.
PAD 1–8
Specify the transmission port for the pads [1]–[8].
PAD 9–16
Specify the transmission port for the pads [9]–[16].
Pedal
Specify the transmission port for the connected pedal.
JyStck–X (Joystick–X)
Specify the transmission port for the X-axis of the joystick.
JyStck–Y (Joystick–Y)
Specify the transmission port for the Y-axis of the joystick.
36
Stick SW
Specify the transmission port for the joystick switch.
Keyboard
Specify the transmission port for the keyboard.
Message
Specifies the transmission port for the MIDI messages transmitted in
Message mode and for MIDI Clock.
3 Press the OCTAVE SHIFT/CURSOR [®] key to proceed to "TxPort"
(select the port).
(Red)
4 Use the [VALUE] dial to select the transmission port.
A (USB Port A)
The MIDI messages assigned to the controller will be transmitted to
port A.
B (USB Port B)
The MIDI messages assigned to the controller will be transmitted to
port B.
Press the OCTAVE SHIFT/CURSOR [√] key to return to "Controller
5
Select," and specify the transmission port for other controllers. ☞Steps
2–4
6 When you have finished making settings for each controller, press the
[ENTER] key. The settings will be updated, and you will return to Play
mode.
If you want to keep the new settings, you must save them in Scene
mode. If you turn off the power or select a different scene without
saving, your new settings will be lost. (☞p.54 "Scene mode–[16]
WRITE")
The port settings are saved independently for each scene.
(Green)