Joystick-X (Joystick-X Assignment); Assigning A Single Midi Message To The +X And -X Directions - Korg microKONTROL Owner's Manual

4 Use the [VALUE] dial or the pads to select the MIDI channel on which
the MIDI message will be transmitted. The range is 1–16 (ch). (☞p.4
"About the trigger pad functions–Input numerical values")
5 Press the OCTAVE SHIFT/CURSOR [®] key to proceed to "Pedal
Type" (specify the type of pedal operation).
(Green)
6 Use the [VALUE] dial to specify the pedal operation.
Momt (Momentary)
The assigned MIDI message will be transmitted with a value of 127 when
you press the pedal, and with a value of 0 when you release the pedal.
Tgle (Toggle)
The assigned MIDI message will be transmitted alternately with values
of 127 and 0 each time you press the pedal.
7 Press the [ENTER] key.
The settings will be updated, and you will return to Play mode.
If you want to keep the new settings, you must save them in Scene
mode. If you turn off the power or select a different scene without
saving, your new settings will be lost. (☞p.54 "Scene mode–[16]
WRITE")
[5] JOYSTICK-X (Joystick–X assignment)
In Joystick–X assignment you can specify the MIDI message and channel
that will be transmitted for left/right (±X) joystick movements. You can
assign separate MIDI messages (or the same MIDI message) to the left and
right (±X) directions.
(Green)
Assigning a single MIDI message to the +X and –X
directions
Here's how to assign a single MIDI message to both left and right directions
of the joystick. You can assign pitch bend, master balance, aftertouch,
velocity, or a control change (CC#).
1 Hold down the [SETTING] key and press pad [5].
The [SETTING] key and pad [5] will light, and you will be in the
Joystick –X assignment page. The main display indicates "Assignment
Select" (select the type of assignment).
In "Assignment Select" you can specify whether a single MIDI
message will be assigned to the entire –X and +X range of the joystick,
or whether separate MIDI messages will be assigned to the –X and +X
ranges.
2 Use the [VALUE] dial to select the assignment method for the left/
right direction. In this example we will select +–Param.
+–Param
A single MIDI message will be assigned to the entire left/right range.
+Prm–Prm
Separate MIDI messages will be assigned to the left and right ranges.
☞p.34 "Assigning different MIDI messages to the +X and –X
directions"
Operation–Setting mode
31