Assigning Aftertouch - Korg microKONTROL Owner's Manual

Operation–Setting mode
Press the OCTAVE SHIFT/CURSOR [®] key to proceed to "Message
3
Select" (select the MIDI message).
4 Use the [VALUE] dial to select the MIDI message you want to assign.
NoAssign
No MIDI message will be assigned to the –X/+X range of the joystick.
If you select NoAssign, the setting will be updated when you press the
[ENTER] key. ☞Step 7
PitchBnd (Pitch Bend)
Assign pitch bend. If you select PitchBnd, press the OCTAVE SHIFT/
CURSOR [®] key to proceed to "MIDI Channel" (specify the MIDI
channel). ☞Step 5
When you operate the joystick in Play mode, the main display will
indicate "PBend---".
MastrBal (Master Balance)
Assign master balance. Master Balance messages [F0, 7F, 7F, 04, 02, vv,
mm, F7] (the device ID is fixed at 7Fh) will be transmitted. If you select
MastrBal, the setting will be updated when you press the [ENTER]
key. ☞Step 7
When you operate the joystick in Play mode, the main display will
indicate "MstBl---".
A.Touch (AfterTouch)
Keyboard aftertouch will be assigned. If you select A.Touch, you can
also select the type of aftertouch. ☞"Assigning aftertouch"
Velocity
Assign keyboard or pad velocity. If you select Velocity, you can also
select the type of velocity. ☞p.33 "Assigning velocity"
32
(Red) (Green)
CtrlChg# (Control Change)
Assign control change. If you select CtrlChg#, you can also select the
control change number. ☞p.33 "Assigning a control change"
5 Press the OCTAVE SHIFT/CURSOR [®] key to proceed to "MIDI
Channel" (specify the MIDI channel).
(Green)
Use the [VALUE] dial or the pads to select the MIDI channel on which
6
the MIDI message will be transmitted. The range is 1–16 (ch). (☞p.4
"About the trigger pad functions–Input numerical values")
7 Press the [ENTER] key.
The setting will be updated, and you will return to Play mode.
If you want to keep the new settings, you must save them in Scene
mode. If you turn off the power or select a different scene without
saving, your new settings will be lost. (☞p.54 "Scene mode–[16]
WRITE")

■ Assigning aftertouch

If you select A.Touch in "Message Select," use "Pressure Type" to select the
type of aftertouch and then proceed to "MIDI Channel" (specify the MIDI
channel).
1 Press the OCTAVE SHIFT/CURSOR [®] key to proceed to "Pressure
Type" (select the type of aftertouch).
(Green)
(Green)
(Green)