Table of Contents
Advertisement
5. Control of a Live image
This chapter describes how to use the controllers for controlling and viewing the images from the connected view
point devices in the desired order. The type of the displayed controller varies according to the connected view
point device model.
To display the controller, click and activate the view window connected to the view point of the desired controller.
5-1. Using the Live Controller
The following procedures are common to all Live View Windows regardless of the connected view point device
models.
View Channel selection
[Title Bar]
This shows the name of the active View Window. A drop-down list is provided to allow the selection of a different
View Window name.
[Stop]
Click on this button to stop the live image recording.
[Rec]
Click on this button to start the live image recording. To stop recording, click on the [Stop] button.
[Snap Shot]
Click on this button to save the image in the form of a still image. (See chapter 10, "Snap Shot" for the snap shot
function.)
[Sequential Display]
Click on this button to enter or exit the sequential display mode. (See section 13-3, "Setting the Sequential Inter-
val" for the sequential display function.)
[View Channel Selection]
The view channel to be viewed can be selected here. (This area is effective only if the sequential display is in the
stop mode.)
12
Advertisement
Table of Contents
