Advertisement
Assembly
Retainer
Socket
Up
4
• Fit a retainer to the outside of the
seat back tube, as shown. Make sure
the socket in the retainer is upright.
• Insert a screw through the hole in
the seat back tube, base wire and
into the inside of the retainer.
• Tighten the screw with a Phillips
screwdriver. Do not over-tighten.
• Repeat this procedure to assemble the other retainer to the other
side of the seat back tube.
• Pull up on the seat back tube to be sure it is secure. If you can
remove either end of the seat back tube, you have not assembled
the retainers correctly. Remove the screws, re-read and repeat
Assembly steps 3 and 4.
Retainer
Socket
Up
8
Seat Back Tube
PULL UP
Advertisement
