Parameter Address Map (Model Id = 42H); Address Block Map; System Parameters - Roland DP990F Implementation

3. Parameter Address Map (Model ID = 42H)

This map indicates address, size, Data (range), Parameter, Description, and Default Value of parameters which can be transferred using and "Data set 1 (DT1)."
All the numbers of address, size, Data, and Default Value are indicated in 7-bit Hexadecimal-form.

■Address Block map

An outlined address map of the Exclusive Communication is as follows;
Address (H) Block
40 00 00

SYSTEM PARAMETERS

40 01 3F
40 1×00
PART PARAMETERS（x＝0-F）
40 2×5A
41 m0 00
DRUM SETUP PARAMETERS
（m＝0-1）
41 m8 7F
48 00 00
SYSTEM PARAMETERS
48 01 10
PART PARAMETERS
48 1D 0F
49 m0 00
DRUM SETUP PARAMETERS
（m＝0-1）
49 mE 17
There are two ways in which GS data is transmitted: Individual Parameter Transmission in which individual parameters are transmitted one by one, and Bulk Dump
Transmission in which a large amount of data is transmitted at once.
■Individual Parameters
Individual Parameter Transmission transmits data (or requests data) for one parameter as one exclusive message (one packet of "F0 ..... F7").
In Individual Parameter Transmission, you must use the Address and Size listed in the following "Parameter Address Map." Addresses marked at "#" cannot be used
as starting addresses.
●System Parameters
Parameters related to the system of the device are called System Parameters.
Address (H) Size (H) Data (H)
40 00 00 00 00 04 0018-07E8
40 00 01#
40 00 02#
40 00 03#
*Refer to section 4. Supplementary material, "About tuning."
40 00 04 00 00 01 00-7F
40 00 05 00 00 01 28-58
40 00 06 00 00 01 01-7F
40 00 7F 00 00 01 00
* Refer to "System exclusive messages related to mode settings".
40 01 10 00 00 10 00-40
40 01 11#
40 01 12#
40 01 13#
40 01 14#
40 01 15#
40 01 16#
40 01 17#
40 01 18#
40 01 19#
40 01 1A#
40 01 :#
40 01 1F#
* The sum total of voices in the voice reserve function must be equal to or less than the number of the maximum polyphony. The maximum polyphony of this
instrument is 128. For compatibility with other GS models, it is recommended that the maximum polyphony be equal or less than 24.
40 01 30 00 00 01 00-07
Individual
Individual
Individual
Bulk
Bulk
Bulk
Parameter
MASTER TUNE
MASTER VOLUME
(= F0 7F 7F 04 01 00 vv F7)
MASTER KEY-SHIFT
MASTER PAN
MODE SET
VOICE RESERVE
REVERB MACRO
Description Default Value (H)
-100.0 - +100.0 [cent] 00 04 00 00
Use nibblized data.
0-127 7F
-24 - +24 [semitones] 40
-63 (LEFT) - +63 (RIGHT) 40
00 = GS Reset,
127 = Exit GS mode
(Rx. only)
Part 10 (Drum Part) 02
Part 1 06
Part 2 02
Part 3 02
Part 4 02
Part 5 02
Part 6 02
Part 7 02
Part 8 02
Part 9 02
Part 11 00
: :
Part 16 00
00: Room 1 04
01: Room 2
10
Description
0 [cent]
127
0 [semitones]
0 (CENTER)
2
6
2
2
2
2
2
2
2
2
0
:
0
Hall 2