Connecting A Computer; Changing The Usb Driver Settings (Usb Driver) - Roland LX-10F Owner's Manual

Connecting a Computer

The following become possible once you connect a USB cable
(available separately) between the USB connector on the LX-10F's
left end of the bottom panel and the USB connector of your
computer.
• You can use the LX-10F to play sounds from SMF music files played
back with MIDI software.
• By exchanging MIDI data with sequencer software, you can save
songs recorded with the LX-10F to your computer, and enjoy a
variety of musical control and editing features.
fig.aaa
Computer
USB connector
* Connect the LX-10F to your computer as shown right.
USB connector
USB cable
Changing the USB Driver Settings
(USB Driver)
Normally, you don't need to install a driver in order to connect the
LX-10F to your computer. However, if some problem occurs, or if the
performance is poor, using the Roland original driver may solve the
problem.
Specify the USB driver you want to use, and then install the driver.
1.
Enter Function mode, choose "USB Driver," and press the
[ ] button (p. 53).
2.
Press the [-] or [+] button to switch "Generic" or
"Original."
Setting Description
Choose this if you want to use the standard USB driver that
Generic was included with your computer.
Normally, you should use this mode.
Choose this if you want to use a USB driver downloaded
Original
from the Roland website.
If you change this setting, turn on the power once again.
This setting is remembered even when the power is turned off.
For details on downloading and installing the Roland original
driver, refer to the Roland website.
Roland website
Here you can download the original driver, and view the
installation procedure and operating requirements.
Roland website: http://www.roland.com/
Connecting to Other Devices
69