Shifting The Pitch (Transpose); Modifying The Note Dynamics (Change Velocity) - Roland PRELUDE MUSIC KEYBOARD 2 Supplementary Manual

Creating a new song

Shifting the pitch (Transpose)

This function transposes the pitches of the specified region.
1. In the "Song Edit Menu," select "6. Transpose" and press
[ENTER].
The SONG EDIT TRANSPOSE screen will appear.
2. Use [ ] [ ] [ ] [
parameter that you want to change, and use the VALUE
dial to make the desired settings.
Parameter Value
Part
ALL, 1–16
From
(MEAS: 0001: 01: 000–
BEAT: TICK)
To (MEAS:
0001: 01: 000–
BEAT: TICK)
Value -127–127
C–(Note Range
Note
Range Min
Max value)
Note (Note Range
Range Max
Min value)–G9
3. Select "EXECUTE" and then press [ENTER].
It is not possible to restore the data to its original state after
executing this operation.
36
] to move the cursor to the
Explanation
Selects the Song part to
be transposed.
Specifies the beginning of
the region to be
transposed.
Specifies the end of the
region to be transposed.
Specifies the number of
semitones by which the
pitches are to be
transposed.
Specifies the lowest pitch
to be transposed.
Specifies the highest pitch
to be transposed.
Modifying the note dynamics
(Change Velocity)
This function modifies the dynamics of the specified region.
1. In the "Song Edit Menu," select "7. Change Velocity" and
press [ENTER].
The SONG EDIT CHANGE VELOCITY screen will appear.
2. Use [ ] [ ] [ ] [
parameter that you want to edit, and use the VALUE dial to
set the value.
Parameter Value
Part
ALL, 1–16
From
0001: 01:
(MEAS:
000–
BEAT: TICK)
To (MEAS: 0001: 01:
BEAT: TICK)
000–
Bias -99–99
Magnify 0 –200%
C–(Note
Note
Range Max
Range Min
value)
(Note Range
Note
Min value)–
Range Max
G9
3. Select "EXECUTE" and then press [ENTER].
] to move the cursor to the
Explanation
Selects the Song part whose
velocity is to be modified.
Specifies the beginning of the
region whose velocity is to be
modified.
Specifies the end of the region
whose velocity is to be
modified.
Specifies the amount by which
the velocity is to be modified.
Allows you to make the
velocity more uniform, or to
decrease or increase the
dynamics.
If Magnify is set near 0%, the
velocity will be adjusted
toward 64, and the Bias value
will be added to each velocity
value. This allows you to make
the velocity more consistent
while adjusting it as desired.
If Magnify is set to 101% or
higher, velocities greater than
64 will be increased while
velocities below 64 will be
decreased, increasing the
dynamics.
If Magnify is set to 100%, the
velocity will not change.
Specifies the lowest pitch
whose velocity is to be
modified.
Specifies the highest pitch
whose velocity is to be
modified.