To Perform Sewing From The Start - JUKI ACF-172-1790 Instruction Manual

② Return the presser.
Press ONE STITCH RETURN button
and the presser returns stitch by stitch.
Press ONE STITCH FEED button
the presser advances stitch by stitch. Return the
presser to the re-sewing position.
Start sewing again.
③
When the SEWING MACHINE START button is
pressed, sewing starts again.
※ For the setting procedure of the start switch,
refer to 2-17. CHANGING MEMORY SWITCH
DATA,p.78.

2-4-2. To perform sewing from the start

① Release the error.
Press RESET button
Then the step motion screen is displayed.
② Return the sewing product to the setting
position.
Press INITIAL POSITION TRAVEL button,
(E) and the presser returns to the sewing product
setting position (start position).
Press CANCEL button
and the presser returns to the sewing product
setting position (start position).
③ Perform again the sewing work from the start.
When the knee switch or hand switch (switch set
to the start switch) is pressed, sewing starts again.
(D),
(E), and
(B) to release the error,
(I) to close the pop-up
40
L
G
H
※ The existing sewing commands
are shown in reverse video in
section G. The kinds of
commands are 5 kinds below.
： Sewing command
： Thread trimming command
： Jump feed
： Thread tension
： Knife drive
※ The existing number of stitches/
number of total stitches are
displayed in section H.
※ Thread tension value is displayed
in section I. When thread tension
command is inputted in the
needle entry point by means of
the external input device, the
button is displayed and thread
tension can be changed.
※ Knife can be cancelled with (K).
K
J
I
E
F
D