Adjusting The Intermediate Stop Position Of The Feeding Frame (Left) (For The Separately-Driven Feeding Frame With A Double-Stepped Stroke Function); How To Use The Plastic Blank (Supplied With The Machine As An Accessory) (For The Separately-Feeding Frame With A Double-Stepped Stroke Function) - JUKI AMS-221EN/IP-420 Instruction Manual

5-3. Adjusting the intermediate stop position of the feeding frame (left)
(For the separately-driven feeding frame with a double-stepped stroke function)
WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start
of the sewing machine.
1 2
5-4. How to use the plastic blank (supplied with the machine as an accessory)
(For the separately-feeding frame with a double-stepped stroke function)
6
Plastc blank
1
Feedng frame (left) for
2
separately-drven feedng frame
Setscrew
3
Washer
4
Nut
5
Postonng screw
6
A
B
5
4
2
1
3
40035093
40032844
SM1041201SC
WP0430801SC
NM6040001SC
SM4040455SP
1) Loosen knob 1 .
2) Adjust the ntermedate stop poston of the
feedng frame by turnng knob 2 so that t
stops slghtly above the sewng product on the
machne.
Turnng knob 2 n drecton A wll ncrease the
heght of the feedng frame n ts ntermedate
stop poston or ndrecton B wll decrease t.
3) After the adjustment, securely tghten knob 1 .
Only the feeding frame (left) is capable
of stopping in the intermediate stop
position.
1) Machne the plastc blank suppled wth the
machne accordng to the sttchng shape.
2) Attach the plastc blank to the feedng frame as
illustrated in the figure shown above.
1. The plastic blank is commonly
used with the frames (right) and
(left) of the feeding frame. Attach
the plastic blank to the frame (right).
2. Use a sponge sheet or rubber sheet
supplied with the machine in com-
bination with the plastic blank, if
necessary.
– 17 –