Automatic Plate Converter - Janome Horizon Memory craft 7700 QCP Instruction Book

z
x
c
v
2
1

Automatic plate converter

Setting for straight stitch
When stitch pattern D1S, D2S or D3S is selected, the
automatic plate converter will close to set up the needle
plate hole for straight stitch.
NOTE:
Use the dual feed device and dual feed foot when sewing
fine fabrics and stretch fabrics for the best sewing results.
The zigzag foot can be used for sewing sturdy fabrics.
Select pattern D1S, D2S or D3S, and the APC setting
window will open.
z If the bobbin thread is pulled out through the needle
plate hole, press the OK key under "Set" and follow the
instructions that appear in the APC setting window.
1 Bobbin thread
NOTE:
Press the OK key under "Ready" to close the plate
converter if the bobbin thread has already been cut with
the automatic thread cutter.
x Hold the bobbin thread and press the OK key.
The bobbin thread will be trimmed automatically.
c Remove the tail of the bobbin thread and press the OK
key.
v The automatic plate converter will close.
2 Automatic plate converter
34