Changing The Presser Foot; Removing And Attaching The Foot Holder - Janome Horizon Memory craft 7700 QCP Instruction Book

3
1
4
1
2
5
6
2
3

Changing the Presser Foot

WARNING:
Turn the power switch off before changing the presser
foot.
Removing the presser foot
Raise the needle to its highest position and raise the
presser foot lifter.
Press the red button on the back of the foot holder.
The presser foot will drop off.
1 Red button
2 Presser foot
NOTE:
If the dual feed device interferes when pressing the red
button, shift the dual feed device away.
3 Dual feed device
Attaching the presser foot
Place the presser foot so that the pin on the foot lies just
under the groove of the foot holder.
Lower the presser bar to lock the foot in place.
Each foot is marked with an identification letter.
4 Groove
5 Presser foot
6 Identification letter

Removing and Attaching the Foot Holder

WARNING:
Turn the power switch off before removing or attaching
the foot holder.
Remove the needle for easy operation.
Removing the foot holder
Raise the presser foot and loosen the thumbscrew.
Remove the foot holder.
1 Thumbscrew
2 Foot holder
Attaching the foot holder
Attach the foot holder to the presser bar from the rear.
Tighten the thumbscrew securely with the screwdriver.
3 Presser bar
Attach the needle after installation of the foot holder.
NOTE:
Lower the presser foot when loosening and tightening
the thumbscrew if it is hard to access.
11